ampac-logo-new-01 SoftwareTraining

ACP-06 Emergency Alarm Initiating Device

The Ampac ACP-06 Emergency Alarm Initiating Device is a re-settable manual call point that has been designed to obtain maximum visibility and high reliability in operation.

Six modes of operation are achievable simply by choosing the appropriate internal connection terminals. All configurations are easily accessed via the screw terminals. The internal printed circuit board is fully enclosed for protection and incorporates a current limiter that maintains a steady supply to the LED.

The ACP-06 Emergency Alarm Initiating Device is supplied in a choice of either flush or surface mount options. Once fitted the front operating element simply snaps into place and is released using the dedicated test and removal tool supplied with each unit. There is the provision of two cable entry knockouts on the rear plus 2 x 3 pre-marked location points on the top and bottom of the surface mount backbox.

  • Easy and economical installation.
  • Visible in the dark via the unique luminescent re-settable element.
  • Six configurations in one unit design for reduced inventory holding.
  • Extremely easy to reset via the robust twist and set key system.
  • Surface mount and flush mount options are available.
  • High impact resistant ABS plastic material.

    Mounting Surface & Flush Mount
    Maximum Voltage 30 V DC
    Minimum Voltage 4.5 Volt if LED with R1 is chosen
    6.0 Volt if LED with R2 is chosen
    Current Rating (Not-Operated) 0 mA
    Current Rating (operated):
    Resister Values
    R1 470Ω
    R2 680Ω
    18 mA @12 Volt - R1
    13 mA @12 Volt - R2
    45 mA @24 Volt - R1
    31 mA @24 Volt - R2
    Cable Termination 0.5 - 2.5 mm²
    Operating Temperature -30 / +70°C
    Humidity 0 - 95%
    IP Rating 42
    Material ABS / Perspex
    Surface Mount
    4105-1018 White Surface Mount Evacuate Alarm Conventional MCP
    4105-1005 Hinged Safety Cover - No text
    4105-1006 Test Keys (Pack of 10)